Features of the Hydraulic Butt Fusion Welding Machine, that is, semi -automatic welding machines, mobile welded machines, and small welded machines will be tested before shipping. A small part is copper bag steel wire, aluminum wire, titanium wire, etc. There are not many customers debug, as long as you pay attention to the following points.

1. Check before debugging

1) Check whether the connection line is correct according to the instructions. Measure whether the insulation resistance of each band -tie area meets the requirements for the insulation resistance of the fuselage.

2) Check whether the ground ground is reliable. Whether the ground wire section is greater than 4mm2

3) See whether the grid voltage is 380V.

4) See if the section of the power wire is selected by 8A/mm2.

2. Debug

1) Inspectify inspection, check whether each button and switch operation of the control device are normal, and then operate the controller welding the current without welding current. Starting welding machines, checking work procedures and pressure processes.

2) Selection of welding parameters

Use 2 sections of the same material and thickness workpieces for trial welding. During the test, the welding parameters (electrode pressure, welding time, welding current, slowdown time, the same extension of the workpiece, the top forging force, etc.) to obtain the welding quality that meets the requirements.

3) Quality test

For the welding of general workpieces, after a certain amount of welding, there should be no excessive indentation, cracks, and over -burning after the visual inspection, and then it can be officially put into use by stretching and bending test.

Features of the hydraulic butt fusion welding machine https://www.dowelding.com/315mm-hdraulic-butt-fusion-html